cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

99
Views
10
Helpful
5
Replies
Beginner

SUP6L-e POST failed.

Hello there.

 

I have a question. 

 

SUP6L-E doesn't properly work. 

 

Is this h/w issue ??

 

Thank you in advance :)

 

B2S#show diagnostic result module 1 test 1 detail

Current bootup diagnostic level: minimal


  Test results: (. = Pass, F = Fail, U = Untested)

  ___________________________________________________________________________

    1) supervisor-bootup ---------------> F

          Error code ------------------> 1 (DIAG_FAILURE)
          Total run count -------------> 1
          Last test testing type ------> n/a 
          Last test execution time ----> Feb 08 2015 23:56:09
          First test failure time -----> Feb 08 2015 23:56:09
          Last test failure time ------> Feb 08 2015 23:56:09
          Last test pass time ---------> n/a
          Total failure count ---------> 1
          Consecutive failure count ---> 1

Power-On-Self-Test Results for ACTIVE Supervisor

prod: WS-X45-SUP6L-E part: 73-14276-02 serial: JAE1652058E
          
Power-on-self-test for Module 1: WS-X45-SUP6L-E

CPU Subsystem Tests ... 
 seeprom: Pass

Traffic: L3 Looopback ... 
 Test Results: Fail

Traffic: L2 Loopback ... 
 Test Results: Fail

Switching Subsystem Memory ... 
 Packet Memory Test Results: Pass


Module 1 Failed

  ___________________________________________________________________________
  ___________________________________________________________________________

5 REPLIES 5
Hall of Fame Community Legend

The supervisor card is dead.

The supervisor card is dead.  You may need to create a TAC Case using this thread.

Beginner

Thank you : )

Thank you : )

Hi, you can try do hard reset

Hi,

 

you can try do hard reset (remove the card and insert back again) . sometime sup card loose connection with back fabric will cause this issue. So mostly resetting card will help the sup to boot.

 

If the sup not recover even after resetting then most probably a hardware issue .

 

HTH
Regards,
VS.Suresh.
*Plz rate the usefull posts *

Beginner

Thank you !! 

Thank you !! 

Hi  Same issue happened many

Hi 

 

Same issue happened many time in our environment for 6500 series switches and solution is to hard/soft reset the module.

 

 If problem persists, problem with sup-engine  

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards