11-05-2008 03:53 PM - edited 03-06-2019 02:20 AM
Please see attached docs for problem details.
11-05-2008 03:56 PM
Problem happened on Oct 30 2008 at 07:56. So ignore logs for other dates.
01-28-2009 04:39 PM
Affected versions does show versions 12.2(18)SXF10 and some versions higher too.
01-28-2009 05:03 PM
Affected versions does show versions 12.2(18)SXF10 and some versions higher too for bug CSCee34416
01-28-2009 07:04 PM
Sound like it's CSCsc33990:
Symptoms: A supervisor engine may unexpectedly reset when the
TestSPRPInbandPing as part of the Cisco Generic Online Diagnostics (GOLD)
fails for 10 consecutive times.
The following syslog error messages are typically generated right before the
supervisor engine resets, and can also be found in the crashinfo files:
%CONST_DIAG-SP-3-HM_TEST_FAIL: Module
failure count:5
%CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=10% RP=0% Traffic=0%
netint_thr_active[0], Tx_Rate[4412], Rx_Rate[0]
%CONST_DIAG-SP-3-HM_TEST_FAIL: Module
failure count:10
%CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=10% RP=0% Traffic=0%
netint_thr_active[0], Tx_Rate[4652], Rx_Rate[0]
%CONST_DIAG-SP-2-HM_SUP_CRSH: Supervisor crashed due to unrecoverable
errors, Reason: Failed TestSPRPInbandPing
Conditions: This symptom is observed on a Cisco Catalyst 6500 series switch
and Cisco 7600 series router that run an integrated Cisco IOS software
image. The trigger for the symptom may be possible corruption in TCAM
entries that are used to perform the TestSPRPInbandPing.
Workaround: Enter the no diagnostic crash global configuration command to
disable exceptions that are being triggered by failed diagnostic monitoring.
However, you should do this with discretion because it may also prevent the
system from taking proactive measure to mitigate problems that could impact
user traffic.
Further Information: The fix for this caveat is more of an enhancement
because it only prevents the system from being over-aggressive in taking
exceptions when the TestSPRPInbandPing fails under specific conditions.
Therefore, the fix for this caveat does not address all triggers that may
cause the TestSPRPInbandPing to fail. Please consult Cisco TAC for further
assistance if you experience the same problem after upgrading to a Cisco IOS
software image that contains the fix for this caveat.
06-25-2015 06:48 PM
I have seen these logs on CISCO7609-S with IOS Version 12.2(33)SRD1.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide