07-15-2014 01:54 AM - edited 03-10-2019 12:27 PM
hi
i have new project in with the bellow product :
20 X WS-C2960-24TC-S
2 X WS-C3750X-48T-S
2 X WS-C2960S-24TS-S
i need to configure this switch in order to work without having vlan, first the 2 core switch for redundancy, then each catalyst switch 2960(edge Switch) connected to the two core with 2 uplink each uplink will be connected to single core switch(i have 2 core switch and i want to configure it in stack mode redundancy)
i need help to configure this switch to work perfectly with each other in best redundancy mode any configuration for this switch will be very helpfull for me
thank you
07-15-2014 01:05 PM
Hey,
This is a very open question but i believe the document below is a good point to start:
http://www.cisco.com/c/dam/en/us/td/docs/solutions/Enterprise/Small_Enterprise_Design_Profile/chap2sba.pdf
HTH.
Regards,
RS.
07-15-2014 10:50 PM
i just need to configure the basic to make the network run only
if any can help me with basic template for edge and core it will be great
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide