cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2786
Views
0
Helpful
2
Replies

switch port blinking green and amber then returns to blink green

Hi ...

I have 3750G 12S and one of its ports is a trunk port connected to another cisco switch, this port works properly with no issues.

But every few minutes it starts to blink green and amber (slowly) for 3-7 seconds and returns to blink green as normal (I didn't notice any problems in both states). It is the only port in the switch that does that.

what could it be ?

1 Accepted Solution

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

Either duplex mismatch or line errors.

Post the complete output (minus IP address &/or description) to the following commands: 

sh version
sh interface <PORT> controll

View solution in original post

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

Either duplex mismatch or line errors.

Post the complete output (minus IP address &/or description) to the following commands: 

sh version
sh interface <PORT> controll

marce1000
VIP
VIP

 

 - Also look at the logs when this happens, preferably use a syslog server as a log-collector, which simplifies the task for 'overviewing' the problem at   longer time frame(s).

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: