cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1071
Views
5
Helpful
2
Replies

switch REP single segment with dual media (combine REP and portchannel)

ahmed
Level 1
Level 1

Hi all,

sorry i edited my question, i need to make REP with double link (4 ports, 2 ports each link, since 1 switch can have no more than two ports that belong to the same segment, so i will user port channel).

 

i have several C9300 and need to make ring topology with double link using port channel. i will use REP.

please share some example configuration for this or simple guide i can follow.

i tried in packet tracer v7 but failed, i can do config port channel mode auto and rep, but if i dissconnect 1 of port, the rep didn't work.

 

if you have some example config it would be great.

thanks

 

Regards,

 

ahmed

2 Replies 2

Hello,

 

I don't think Packet Tracer lets you fully configure REPs.

 

The link below is for the Catalyst 1000 switches, but it should work on the 9300 the same way.

 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst1000/software/releases/15_2_7_e/configuration_guides/lyr2/b_1527e_layer2_c1000_cg/configuring_resilient_ethernet_protocol.html

jmcgrady1
Level 1
Level 1

A related question: Say i have ten 9300 switches in a ring. Can i run two separate REP rings across them? Both carrying all vlans? Or is only one REP ring possible?