06-11-2015 01:11 AM - edited 03-08-2019 12:30 AM
anybody can tell me that the use of spanning-tree Command.
where we configure spanning tree on Router or switch?
Solved! Go to Solution.
06-11-2015 01:19 AM
Dear vaishkhan161190,
if you want to prevent loop in your switch network u can use spanning tree protocol. spanning tree is a mechanism that will prevent from infinite loop of packets.it is a Layer 2 protocol so no need to run on routers because routers are L3.
pls read the folloing like
http://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/5234-5.html
I hope it was Informative .
Regards
Hossein
06-11-2015 01:19 AM
Dear vaishkhan161190,
if you want to prevent loop in your switch network u can use spanning tree protocol. spanning tree is a mechanism that will prevent from infinite loop of packets.it is a Layer 2 protocol so no need to run on routers because routers are L3.
pls read the folloing like
http://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/5234-5.html
I hope it was Informative .
Regards
Hossein
06-11-2015 01:24 AM
Thamks Mr. Hossein
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: