system:default-running-config on 3560G with same IOS different
Whilst working with the autoinstall feature, which on a 3560G is dependant on VLAN1 being enabled and configured for DHCP Client mode I noticed that some switches would not pull DHCP, whilst some would.
My findings show the following:
In the system:default-running-config file, which contains default settings for all paramaters some devices had VLAN 1 shutdown and no ip address configured. Whilst some devices had DHCP Client and no shutdown configured.
The devices are all the same model (3560G) running the same IOS version and licence level. Does anyone know why this would be different?
Yes I'm aware of that. The DHCP Server is a dedicated machine, but this is not relevant. The matter of discussion is that VLAN 1's default configuration varies on different same model switches with the same IOS version running.
This is a deployment scenario where VLAN 1 is being used during bootup only. Therefore it does not pose a security risk.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...