Ok, so I got a new 2960 shipped to one of my sites to replace a fried switch. Once the switch was plugged into the network, I found it's address and opened the http interface. Once in the switch I selected express setup, set the options and entered the switch password and telnet password. Immediately after that it started asking me to enter username and password for level_15_access. I entered the password that I had set, but it won't accept it. I can open a telnet session to the switch with the password I set, but it won't accept the switch password for the enable password. I tried to access it with CNA too, but it fails as well. What's the trick to getting back into enable mode on this thing?
