Trunk configuration is not working in cisco switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2024 09:28 PM
When we checked output below outputs for your reference
#int xxx
#switchport mode trunk
#show int xxx switchport
Administrative Native VLAN tagging: Disabled
Missing
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL
- Labels:
-
Catalyst 9000
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2024 10:10 PM
Can you share all output
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2024 11:00 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2024 11:12 PM
It OK' this health trunk
Oper and admin is both trunk and that perfect.
""Administrative Native VLAN tagging: Disabled "" this defualt' the Cisco not tag native vlan' you can change defualt but in special cases.
""Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001"" this also OK you not config allow vlan so it by defualt allow all vlan.
""Capture Mode Disabled
Capture VLANs Allowed: ALL"" this when we use vlan list to capture traffic and it by defualt disable.
So every thing is OK.
MHM
