Unable to issue "show ip port-map" command

[markgramlich]

We are unable to issue the command "show ip port-map".

We logon to the router. Issue "enable". Get the privileged exec command prompt (router8#). When we issue "show ip p?", the list returns "pim", "policy", "prefix-list" and "protocols". But, no "port-map" entry.

We are running Version 12.3(14)T1 of IOS.

TIA

[thisisshanky]

Are you able to execute other commands such as show ip route etc ??

Do you have ip port-map commands enabled in the running config ?

[markgramlich]

Yes. We can execute "show ip route" and other commands.

We are working on building some ip port-maps. We issued one ip port-map command. That's when we went back to see what was in the port-map table by executing the "show ip port-map" command.

[markgramlich]

The syntax changed.

To display the current protocol-to-port mappings in use by Network-Based Application Recognition (NBAR), use the show ip nbar port-map privileged EXEC command.

show ip nbar port-map [protocol-name]