Uplink Level

[mohamedalthaf]

Hi

I have two switch both are uplink 10GB at fiber  connection 

normally my data transfer less 1GB

how to check the 10GB  bandwidth support in switch level  command  and tools

Not this any other or any tools

sh interfaces tenGigabitEthernet 2/0/1

[InayathUlla Sharieff]

Hi,
Kindly check with the following:-
show int tenGx/x

5 minute input rate xxxx bits/sec, 124 packets/sec
5 minute output ratexxxx

sh interfaces tengig x/x summary

regards

Inayath

[mohamedalthaf]

i need check uplink 10GB interface capability also 

any dummy data transfer check any command 

[InayathUlla Sharieff]

Thats the cmd to check at the interface level.

Else you can you any third parth software to achieve this.