Viewing Debugging when Telneting to a Cisco Router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2006 10:33 PM - edited 03-05-2019 01:30 PM
Hi,
I ran the a debug on a Cisco router through Telnet and I entered the command "show terminal" which should, I believe, show me the output of the debug remotely but I am still not able to see it.
Can you please help me in this?
Thanks,
Haitham
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2006 10:48 PM
Hi Haitham,
You need to enable "terminal monitor" to see the debugs when you have access the router through telnet.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tcf_r/cf_12ht.htm#wp1037494
HTH
Ankur
*Pls rate helpfull post
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2006 11:44 PM
Dear haitham
You can check this
no logging console in configuration mode
sh log on exec mode
Regards
Ajay
