Hi All,
I'm looking to create a Vendor VRF on one of my 3945E routers. I have my 'default' VRF running eigrp with all my branches. I have created a subinterface to my WAN, and assigned the interface to the vrf VENDOR.
I have EIGRP running across my default routing table and EIGRP running across the VRF. This part I don't have a problem with.
I am wondering how I can get routes from my VENDOR vrf into the 'default' vrf on the router. I know I can accomplish this via route-target importing / exporting via the VRFs, but since I'm using the default vrf on the router, how can I get routes from my VENDOR vrf into my regular VRF? I have control of the router at the vendor location, I just want to keep is seperated 'just in case'.
Router in question: 2x 3945E 15.2-2
Remote 'vendor site' router: 1921, 15.2
3900 Config:
ip vrf VENDOR
rd 10:1000
interface FastEthernet0/1.96
bandwidth 100
description Vendor WAN VLAN
encapsulation dot1Q 96
ip vrf forwarding VENDOR
ip address 192.168.96.1 255.255.255.0
ip summary-address eigrp 10 0.0.0.0 0.0.0.0 5
router eigrp 10
passive-interface default
no passive-interface FastEthernet0/0
no passive-interface FastEthernet0/1.95
no passive-interface FastEthernet0/1.96
network 192.168.95.0 0.0.0.127
network 192.168.100.8 0.0.0.3
no auto-summary
!
address-family ipv4 vrf VENDOR
network 192.168.96.0
no auto-summary
autonomous-system 10
exit-address-family