VRRP issue between Cisco and Juniper device

[zizou6500]

Hi Community,

I've made a VRRP setup between Cisco & Juniper device as below:

1/ On the Cisco devices:

- Two interfaces connected to the Juniper devices:

Gi1/1 (mode access )--> Junipr 1

GI1/2 (mode access ) --> Juniper2

The L3 config is under an SVI (the vlan id is being extended to the juniper devices).

2/ VRRP config on the Juniper device

The issue is that I can't ping the VRRP IP from the Cisco device. On the ARP table, I'm seeing only the real IP addresses of the Juniper devices.

Does anyone experience the above, I'm planning to change the configuration to trunk mode but I'm not sure that it will fix this issue.

I need your assistance here, thank you in advance!

[Mark Elsen]

                            - Check if these info-resources can be useful :

           https://blog.marquis.co/vrrp-between-cisco-and-juniper-switches/

           https://ultraconfig.com.au/blog/vrrp-configuration-between-a-cisco-ios-xe-and-junos-router/

 M.

[zizou6500]

Hi @Mark Elsen,

Thank you for your help.

But in my case, there is no VRRP config on the Cisco device. It's only on the Juniper devices.