Hello,
I have two locations each with a 3560G and a wireless bridge between them capable of 60Mbps TCP. I am seeing output drops on the 3560G's because of the limited bandwidth of the wireless link, and I have setup the ports on the 3560G's as follows but I continue to have output drops.
description TR-BVS
switchport trunk encapsulation dot1q
switchport trunk native vlan 2089
switchport trunk allowed vlan 2089
switchport mode trunk
bandwidth 60000
speed 100
srr-queue bandwidth shape 10 2 0 0
srr-queue bandwidth limit 60
priority-queue out
mls qos trust dscp
GigabitEthernet0/20 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 64d9.8981.d994 (bia 64d9.8981.d994)
Description: TR-BVS
MTU 1500 bytes, BW 60000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 3/255, rxload 21/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:19, output hang never
Last clearing of "show interface" counters 2w0d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 243060
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 5992000 bits/sec, 734 packets/sec
5 minute output rate 1075000 bits/sec, 476 packets/sec
496160280 packets input, 479198649478 bytes, 0 no buffer
Received 1029994 broadcasts (989434 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 989434 multicast, 0 pause input
0 input packets with dribble condition detected
334695405 packets output, 90549065701 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Is there anything else I could try on these switches to see if I could elimiate the output drops?
Thanks,
Dan.
