WS-C3750X-24T-L no switchport command
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:30 AM - edited 03-07-2019 06:14 PM
We have WS-C3750X-24T-L with c3750e-universalk9npe-tar.152-1.E1.tar IOS when i try to cammand no switchport it is not accepting the command any license required for this command.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:34 AM
Your switch probably has IP Base license.
"no switchport" is an IP Services feature command.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:37 AM
Hi,
Check the license you use. It is likely lanbase, so switch does not accept any L3 commands. You need ipbase.
Kind Regards,
Ivan Shirshin
**Please grade this post if you find it useful.
Ivan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:42 AM
Thanks for your replay with out ipbase license how to configure no switchport command any other options and commands suggest me.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:48 AM
You cannot. Lanbase license does not allow you to use any L3 features, they are blocked.
Kind Regards,
Ivan Shirshin
**Please grade this post if you find it useful.
Ivan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2014 02:56 AM
Thanks for your replay with out ipbase license how to configure no switchport command any other options and commands suggest me.
Depends on what you license your 3750X has. If you have IP Base, then you need to contact your authorized Cisco reseller and they can organize to get a permanent IP Services license installed.
In the meantime you can get a 30-day Evaluation license enabled.
