Resolved! Python
Hello, I would like to know why my output for installed libraries is lesser than the output in DevNet course.
Forum Posts
Resolved! Need Visio Stencil for C9800-L
Need Visio Stencil for C9800-L
Hello, While searching through Cisco's Visio Stencils page, I have been unable to find the stencil for the Catalyst 3560G Series PoE-24. I have searched through the 'Switches - Catalyst 3560' and the 'Switches - Catalyst 2560CS' packages, and was una...
Hello, I would like to know what the Mean Time Between Failure (MTBF) or Failure Rate value is for PN: : C9500-40X-E.
Resolved! How to request missing Visio stencils?
There are several Visio stencils that are missing from the library that I need. They're important to me (and I imagine others want them too) as I need to do rack elevation diagrams. I hate to open a TAC case on them but not sure what else to do. Any ...
I need the Vis3 Stencil for the RV340, but I am not finding it anywhere on the internet, does anyone know where it is possible to download it?
The page with Visio stencils is listing ISA3000 and IC3000 is physically identical except the name on the faceplate. Can we add one new stencil based on ISA3000 with the IC3000 naming? https://www.cisco.com/c/en/us/products/visio-stencil-listing.ht...
So my phone froze up and I held down the power button. When it rebooted it showed that I had missed a call from +1552546429 when I called it I got an answering service that said thank you for calling sorry and leave a message my first pound a bunch o...
All, I've been tasked with trying to find out all extensions in the Call Manager that are forwarded off premise. I'm a TDM guy and have very limited knowledge of UC, so If you have any ideas or give me an answer please keep it as vanilla as possible...
Hi I don't see a Visio stencil for the Cisco 4221 router listed so it's challenging to produce Visio engineering drawings without them. Can the Cisco 4221 be created please? Regards Jon
I would like to submit a request for Cisco branded Visio stencils around our Firepower 1000 Series and 2000 Series Next Generation Firewalls to be posted here: https://www.cisco.com/c/en/us/products/visio-stencil-listing.html
Need Visio stencils for the Firepower 1100 Series - specifically in my case for the 1140.
In the Optical Networking - NCS 2000 stencil, one of the shapes titled NCS2K-400G-XP has the TX and RX locations swapped on just the port 11 and port 12 from what is actually on card. Can the shape be updated and reposted?
Visio stencil currently missing as of the 3/20/2020 release
How can I change my username
