Integrating CTS3210 and CTS1300 with RadVision

[wanes.italtel]

Regards,

How I can integrate CTS3210 and CTS1300 with RadVision ?

1) I can integrate them only CUCM with GK RadVision by H.323 trunk to CTS3210 and CTS1300 communicate with RadVision endpoints end-to-end by RTP?

OR

2) I can integrate CUCM - VCS with GK RadVision by H.323 trunk to CTS3210 and CTS1300 communicate with RadVision endpoints by RTP through TelePresence Server 8710 ?

Best Regards

Marques

[Marwan ALshawi]

it depends on the cucm and cts versions

if you use cucm version 8.6 and later and cts 1.7.4 and later you can have direct call to via CUCM

however there will be no video transcoding

if any video transcoding required then you will need the TP server or MXE in the RTP path

for more details see this ask the expert session Q&A might help you

https://supportforums.cisco.com/thread/2123753

hope this help

if helpful Rate

[wanes.italtel]

Hello marwanshawi,

In both scenarios below can you inform the links for configure ?

1) if you use cucm version 8.6 and later and cts 1.7.4 and later you can have direct call to via CUCM

however there will be no video transcoding

2) if any video transcoding required then you will need the TP server or MXE in the RTP path

Best Regards.