No web access on Cisco expressway

[Luis Rodriguez]

Hi,

I have just installed new expressway VMs running version X12.5.3 and I can access them just fine via CLI, I have enabled web access using the following command:

xConfiguration Administration https Mode: On

But when I try to access the web GUI it just stays there doing nothing, should I do something else to enable it?

[abcdedghi1]

Hey Luis

xConfiguration Administration HTTP Mode: On
xConfiguration Administration HTTPS Mode: On

these commands should do the trick. try using a different browsers like chorme or firefox. Worst case reboot it. But this should do the trick.

i hope you dont have any firewalls in the middle or anything like that.