TelePresence and Video Infrastructure

OK CISCO ... 1.  Installed CISCO WEBEX Room 70 G2.  2. Upgraded firmware a couple weeks ago to Ce9.8.03. The system just started display a warning that the camera software is not compatible with codec ???? What is the fix please as this had been work...

Hi,We have a C20 Cisco Tandberg which has a recent strange behavior. Basically, it calls himself every ten seconds when on without visio. During a visio, the C20 disconnects every five minutes.Do you have any ideas of what is happening ?Thanks. Fabri...

Hello,    We have a few Sparkboards that we only was to use as room displays. Do we have a way to default the board to HDMI in only to displayed. 

Calls to some of our registered SX10/SX20 endpoints (usually from Zoom, but not always) end up with one-way video.  The media paths shown in xstatus are address of the far-end system.  There does not seem to be any obvious  way to get our endpoints t...

DearsI am planning to purchase a Video Endpoint webex kit plus  for B2B calls  for only 1 meeting room and a CMS with part number CTI-CMS1KM5-BUN-K9  and R-CMS-K9,,,I am  buying the SMP license in the Video endpoint configuration (CMS-SMP-EP) and als...

     We just received a Cisco CHS 435HDC set-top box from Verizon and replaced the Direct TV Set-top box that was installed. Video was displaying fine with the Direct TV box, but when we hooked everything up to the CHS box we only got a blue screen t...

I am using Cisco Webex room Kit Pro in one of my project, along with codec I have Quad camera and Precision 60 camera. While integration I am experiencing issue with camera control,  I am able to control only one camera even I connect both camera to ...

Hi,Can one extend the antenna on the Codec Pro?I ask because I have a site that is installing the codec with a projector and the codec will be located at their sound room. Thanks

Dear friend, I do have a problema whith my Precision HD 40 camera that we uses in SX20 kit. The camera did not start and as a result fo it, the code didn't find it and says NO CAMERA DETECTED.It stays with a white light on the base and do some wierd ...

Hi team, Have you ever done this cenario of configuration with expressway C and E integrated with Cisco BE7K with cucm, cuc, imp in the version 11.5? Does anybody knows if the palo alto firewalls support expressway with dual nic and dmz? Best regar...

Hi all,Is it possible to exclude a Cisco endpoint from registering via TMS without deleting it from TMS?For example, we run a statewide government video conference network, over 1500 endpoints, we recently updated endpoint software to patch a securit...

I have a CMS sever setup in a single combined deployment.  This is a lab server that I am setting up for testing purposes.  The version is 2.5. I have setup the webadmin with a internal signed cert and used selfsigned certs for the callbridge, webbri...

Can the meetings button show on the touch 10 when in-call?