SX80 IP to IP dialing and registered to CUCM for VOIP

[Sean Alexander]

Hi All,

Is it possible to configure an SX80 for H323 IP to IP dialing and have it registered to CUCM for voice calls via SIP.

I assume this cannot be done using native registration but what about as an 3rd Party SIP device?

Any info would be appreciated, been doing a lot of searching and not having any luck.

Thanks,

[Patrick Sparkman]

H323 is disabled when you register endpoints to CUCM and as a result IP dialing isn't possible, this is because CUCM is SIP only. Although, if you have a VCS or Expressway in your deployment, you can implement a workaround to make it possible, see the document linked below.

Dial IP Addresses from Endpoints Registered to CUCM with VCS / Expressway Configuration Example