Table 60 microphone pinout

[5thdoctor]

Can anyone tell me the pin out for a Table 60 microphone? A tech in our shop removed the phoenix connector from the lead before noting them and now finding any useful technical documentation hard to find. There are four wires: a red, green, blue/black, and uncolored/metallic. We are re-terminating ours to a 3 pin XLR and only need the 3 wires for microphone signal, not control, as microphone muting will be performed by a Biamp Tesire via touch panel control.

I'm assuming metallic= ground, red=+, blue= -, and green= control, but would like confirmation.

[Patrick Sparkman]

I have't been able to find a diagram yet for this microphone, however the pin-out you suggest makes sense and sounds correct, but I understand you want to make sure so not to ruin the microphone.

[G* · Accepted solution]

I have a new one with the wires in the following order

1: red = +

2: green = -

3: mettalic = G

4: blue = mute control