cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
640
Views
0
Helpful
2
Replies

TMS select only MCU, when two MCU are available

sivashanmugam g
Level 1
Level 1

Hi All,

I have two MCUs, one for US sites and another for UK sites. Both are configured in TMS to host multi point conference. While scheduling Video conference, TMS always select the UK MCU. Even the End points in US site. I observed TMS id is 5 for UK MCU and TMS ID is 12 for US MCU.

Please let me know , what are the parameters i need to check in MCU and TMS?

how to verify IP zones on TMS and MCU?

Thanks in advance !

Regards,

Siva

1 Accepted Solution

Accepted Solutions

daleritc
Cisco Employee
Cisco Employee

Take a read through the TMS Admin doc, in particular the Routing chapter:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tms/admin_guide/Cisco-TMS-Admin-Guide-14-3-2.pdf#page44

Sent from Cisco Technical Support iPad App

View solution in original post

2 Replies 2

daleritc
Cisco Employee
Cisco Employee

Take a read through the TMS Admin doc, in particular the Routing chapter:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tms/admin_guide/Cisco-TMS-Admin-Guide-14-3-2.pdf#page44

Sent from Cisco Technical Support iPad App

Thank you Dale



Sent from Cisco Technical Support iPhone App