Hi All UC Experts,
I set the VCS Conductor TPS for the Polycom video endpoints. All Polycom video endpoints registered to the VCS by SIP only, that wan t to make the video conference between the Polycom endpoints and Cisco video endpoints.
Now, it is working to use the TPS video resources through the VCS -> Conductor -> TPS.
But, the sharing screen on Polycom, that looking like is not a BFCP protocol (not sure) and the sharing ppt on Polycom is the signal video stream, so the participants (even on the same ploycom platform) are seeing the sharing ppt only (cannot see the video screen on the Polycom sharing ppt).
Actually, I tried to tune the SIP adv. values on the zone on VCS (to Conductor), but fail too
Any idea on that? That is no way to do? because TPS is no H323 support until now?
