cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1216
Views
0
Helpful
1
Replies

Cisco SX10 Support

evanande
Level 1
Level 1

I'm having trouble connecting our SX10 to our TV in our conference room. We are connecting it with an HDMI and PoE. No matter what HDMI input it is in, nothing shows up on the TV. It is a Vizio. Any troubleshooting suggestions are welcome. Thank you.

1 Reply 1

Wayne DeNardi
VIP Alumni
VIP Alumni

OK, we'll start with the obvious...

  1. Is the Input Source on the TV set to the port that you have the SX10 connected to?
  2. Is the HDMI cable connected to the HDMI (video out) port on the SX10 (the one on the same side as the ethernet and USB ports, not the one on the side where the VGA and microphone sockets are as that is in input for connecting a device such as a laptop.
  3. You say you are using PoE to power the SX10 - is the network swtich you are connecting to capable of providing power over the ethernet cable, or is it just a normal ethernet switch?
  4. Does the power light light up when the device is powered and the button is pushed to turn it on?
Wayne
--
Please remember to mark helpful responses and to set your question as answered if appropriate.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: