Catalyst 9300X シリーズスイッチの Stack bandwidh には、High Speed モードと Low Speed モードがあります。
スタックを構成するスイッチでモードが一致していない場合、正常にスタックを構成できませんので、ご注意ください。
Stack bandwidhがどちらに設定されているかは、以下のコマンド出力で確認できます。
以下の出力例では High Speed モードに設定されている事が確認できますが、Low Speed モードの場合は、Bandwidth が 480G と表示されます。
C9300X#show switch stack-bandwidth
Stack Current Next Boot
Switch# Role Bandwidth State Bandwidth
------------------------------------------------------------
*1 Active 1000G Ready 1000G
Stack bandwidh の設定変更は、グローバルコンフィギュレーションモードで switch stack-speed [high | low]コマンドを使用します。
以下の出力例では、High Speed モードに変更しています。
yes を選択した後、機器の再起動を実施すると設定が適用され Stack bandwidh が変更されます。
C9300X(config)#switch stack-speed high
WARNING: Please confirm all switches physically connected to the stack are in Ready state with 'show switch' CLI command. Otherwise, some switches may not be able to join the stack after the reload, due to speed mismatch.
Stack bandwidth setting can be verified using 'show switch stack-bandwidth' command. It will require a reboot for the new stack speed to take effect.
Do you want to continue?[y/n]? [yes]:
各バージョンのコンフィギュレーションガイド等もご参照ください。