IOS-XE Router ではNAT+HSRP 併用時に以下注意点があります。
「ip nat inside source static x.x.x.x x.x.x.x redundancy ○○」で設定されている場合、
redundancy 後の Parameter を outside Interface に所属する HSRP group name に設定する必要があります。
設定例:
!
interface GigabitEthernet0/0/1
ip address 10.1.1.1 255.255.255.0
ip nat outside
standby 20 name hsrp20
standby 20 ip 10.1.1.254
standby 20 priority 110
standby 20 preempt
negotiation auto
!
interface GigabitEthernet0/0/2
ip address 20.1.1.1 255.255.255.0
ip nat inside
standby 10 name hsrp10
standby 10 ip 20.1.1.254
standby 10 priority 110
standby 10 preempt
negotiation auto
!
上記のような設定ですと、hsrp20 を設定する必要があります。
ip nat inside source static 192.168.1.250 10.1.1.250 redundancy hsrp20 <<<
redundancy 後の Parameter を inside Interface に所属する HSRP group name (上記設定例の場合はhsrp10) に設定すると、追加された NAT エントリがルーティングテーブルへ反映されなかったりなど、NAT 及び HSRP が期待通りに動作できない可能性がありますので、ご注意ください。
参考資料:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_nat/configuration/xe-16/nat-xe-16-book/iadnat-ha.html
When an Address Resolution Protocol (ARP) query is triggered for an address that is configured with NAT static mapping and owned by the device, NAT responds with the burned in MAC (BIA MAC) address on the interface to which the ARP is pointing. Two devices act as the Hot Standby Router Protocol (HSRP) active and standby. You must enable and configure the NAT outside interfaces of the active and standby devices to belong to a group.