ASR は2種類のRP redundancy modeがあります。
RPR Route Processor Redundancy とSSO Stateful Switchover になります。
RPR を使用すると、スタンバイ RP を設定することができます。RPR を設定する場合、
スタンバイ RP はブートアップ時に Cisco IOS ソフトウェアをロードし、スタンバイ モードで自身を初期化します。
アクティブ RP で重大なエラー イベントが発生した場合、システムはスタンバイ RP に切り替えて、
アクティブ RP として自身を再度初期化します。
このイベントでは、システム全体がリブートされるため、RPR によるスイッチオーバーは、
Nonstop Forwarding/Stateful Switchover(NSF/SSO)など、
その他の HA スイッチオーバー機能に比べて速度が遅くなります。
SSO 機能では、プロセッサの 1 つをアクティブ プロセッサとして確立し、
もう一方の RP をスタンバイ プロセッサとして指定してから、
これらのプロセッサ間でクリティカル ステート情報を同期化することにより、
プロセッサの冗長性を実現しています。SSO では、2 つのプロセッサ間の最初の同期化のあと、
RP のステート情報をデュアル プロセッサ間でダイナミックに維持します。
RPR Modeの設定
!
redundancy
mode rpr
!
ASR_B#sh redundancy
Redundant System Information :
------------------------------
Available system uptime = 3 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = rpr
Operating Redundancy Mode = rpr
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 3 minutes
Image Version = Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVIPSERVICESK9-M), Version 12.2(33)XNF1, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Wed 28-Apr-10 17:26 by mcpre
BOOT = harddisk:asr1000rp1-advipservicesk9.02.06.01.122-33.XNF1.bin,12;
CONFIG_FILE =
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 7
Current Software state = STANDBY COLD
Uptime in current state = 1 minute
Image Version = Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 12.2(33)XNE, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Wed 25-Nov-09 00:14 by mcpre
BOOT = harddisk:asr1000rp1-advipservicesk9.02.06.01.122-33.XNF1.bin,12;
CONFIG_FILE =
Configuration register = 0x2102
SSO Modeの設定
!
redundancy
mode sso
!
ASR_B#sh redundancy
Redundant System Information :
------------------------------
Available system uptime = 12 minutes
Switchovers system experienced = 0
Standby failures = 1
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 12 minutes
Image Version = Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVIPSERVICESK9-M), Version 12.2(33)XNF1, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Wed 28-Apr-10 17:26 by mcpre
BOOT = harddisk:asr1000rp1-advipservicesk9.02.06.01.122-33.XNF1.bin,12;
CONFIG_FILE =
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 7
Current Software state = STANDBY HOT
Uptime in current state = 0 minutes
Image Version = Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 12.2(33)XNE, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Wed 25-Nov-09 00:14 by mcpre
BOOT = harddisk:asr1000rp1-advipservicesk9.02.06.01.122-33.XNF1.bin,12;
CONFIG_FILE =
Configuration register = 0x2102