Adding a Cisco 2901 to CUCM

[Adamciscoaccount]

Hello All,

I have a Cisco 2901 which I have added to CUCM via the gateway section, using a MAC address off of one its live networked ports.

In my Cisco 2901 I have an FXS card which I have also added to call manager, with a port that I have attached a number to out of my call manager directory ready for the device I will be plugging in.

Aside from testing the device on the day, how can I tell that my router has actually connected properly with CUCM? Is there a show command I can do in the CLI of the device? Will my config trickle down from CUCM to the 2901 in regards to voice-ports ect?

Apologies I haven't done any voice courses or work any advice is greatly appreciated.

[Jitender Bhandari]

Hi,

How are you trying to add this to CUCM, you would have to choose a protocol 

MGCP \ H323 \ SIP ?

JB

[Adamciscoaccount]

Hello thanks for your response,

The options I have when adding a device are mgcp and sccp, we use sccp

[Jitender Bhandari · Accepted solution]

Hi

For adding it as SCCP see below.

https://supportforums.cisco.com/document/12450616/stcapp-how-configure-fxs-ports-cucm

For MGCP

https://supportforums.cisco.com/document/90521/mgcp-gateway-integration-cucm-and-pstn-service-provider

http://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/23966-mgcp-pri-cm.html

https://www.youtube.com/watch?v=-QwICmRqfx4

for H323

https://supportforums.cisco.com/document/99806/adding-h323-gateway

https://www.youtube.com/watch?v=q82qf9HJkyw

for SIP trunk

https://supportforums.cisco.com/blog/12108326/implementing-sip-gateways-cucm

What is the purpose of adding this gateway, what are you trying to achieve.

(Rate if it helps)

JB

[Adamciscoaccount]

Thank-you for your quick responses, this is 100% what I need I believe there is afew commands missing in the router's cli that I hadn't been aware of.

[Jitender Bhandari]

Happy to help,

Thanks for updating the post.

JB