Cisco Call Studio 10.5
Question #1
I have created a Call Flow that contains a Web Service call - multiple sub-flows with multiple web service calls. Created call flow - highlighted the web service element select File (from DD box) and load the WSDL from a local file. Loads without any issue and then Configure the Web Service Call (the Operation, Request, Response). The Call Flow is saved, validated, Deployed to server - works without issue.
Sometimes after closing the project and re-opening the Call Flow with the Web Service element receive an error (unable to load the WSDL) with result of losing the web service elements configuration. This appears to occur randomly - other sub-flows that uses the same WSDL file may/may not have the same issue. Requires configuring the Web Service element again. Is this a CVP 10.5 issue or something else?
Note the WSDL file is on local drive (same as CVP 10.5). WSDL File properties shows Full access. Windows 7 O/S.
Question #2
Is there a method for the Call Flow to use an externalized Web Service URI (not the one in the WSDL)? Development and Production Call flows use different Destination URI's which appears to require to have different versions of the Call Flow (one for development and one for Production).
