Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
724
Views
0
Helpful
2
Replies

Configure -> Phones missing from UC 500 Series Administration

rymanconstruction
Level 1
Level 1

‎10-03-2010 05:06 PM - edited ‎03-19-2019 01:41 AM

I recently upgraded a UC-520 system from a very old version of CUE to the latest version 8.0.4.  (UC 500 Series - Administration Version 8.0.2).  I restored factory default because I had some issues and wanted to start fresh.  Everything went seemingly well including TCP/IP setup, DHCP items, SIP Trunk configuration, etc.  I can make and receive calls on the system just fine.  I cannot seem to find where to configure the phones.  I normally configure custom buttons, setup the users' name at the top, etc.  I used to go to "configure" -> "phones" in the web admin console and now the option is not there.  Did I forget to install something?

Labels:
0 Helpful
2 Replies 2

rymanconstruction
Level 1
Level 1

‎10-04-2010 06:52 AM

My other issue that is a result of this problem is that when I add a new user to the system and attempt to select an unassociated phone, no extensions (phones) are in the list.  I do see them however in the CCA topology map.  I am sure I either installed something incorrectly or forgot to install something.

0 Helpful

rymanconstruction
Level 1
Level 1
In response to rymanconstruction

‎10-04-2010 01:16 PM

Another update during troubleshooting, I am able to associate a phone with a user as long as I create the user first and then associate the phone.

0 Helpful
Customers Also Viewed These Support Documents