I just installed a CUE 2.2.1 in a lab (it's in a 3745 with CME 3.2 running IOS 12.3-11T8). I copied the config from a working CUE 1.1.2. The phones are registered and I can call the AA but when I enter the * or # sign, it just starts the prompt over again. When the call gets forwarded on a RNA, I get a fast busy. Likewise, hitting the message button gets a fast busy. The dial by name or extension works, however. Anyone know what I'm doing wrong? It's a simple network right now, several phones, a 3550 and a 3745. Any ideas would be helpful. Thanks. I put some of the configs below.
CME
!
dial-peer voice 2 voip
description dial peer for MWI,VM,AA
destination-pattern 1...
voice-class codec 1
session protocol sipv2
session target ipv4:172.170.2.10
ip qos dscp cs5 media
ip qos dscp cs5 signaling
no vad
!
CUE
ccn application autoattendant
description "autoattendant"
enabled
maxsessions 4
script "aa.aef"
parameter "MaxRetry" "3"
parameter "operExtn" "0"
parameter "welcomePrompt" "AAWelcome.wav"
end application
ccn application ciscomwiapplication
description "ciscomwiapplication"
enabled
maxsessions 4
script "setmwi.aef"
parameter "strMWI_OFF_DN" "8001"
parameter "strMWI_ON_DN" "8000"
parameter "CallControlGroupID" "0"
end application
!
ccn trigger sip phonenumber 1000
application "voicemail"
enabled
idletimeout 5000
locale "en_US"
maxsessions 4
end trigger
ccn trigger sip phonenumber 1003
application "autoattendant"
enabled
idletimeout 5000
locale "en_US"
maxsessions 4
end trigger