DID configuration help

[arpraveen_ar]

I am using CME 4.1.I want o enable Direct inward dialing in my router.My pstn no is 024481415 and my extension is in range of 200-300.

My requirement is when somebody call to my PSTN no: with extension .the call should go to the corresponding extension without going to reception.

under telephony-service i have configured below command

dialplan-pattern 1 0244814152.. extension-length 3 extension-pattern 2..

it is not working after giving the above command

i think some extra configuration is needed.I am entirely new to voip.Please help me out to solve my problem.

[Adrian Saavedra]

Hi friend,

Please check this links, may be helpful.

Dial-Plan Patterns, DID Trunk Lines and SCCP Configuring Dial-Plan Patterns:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmedialp.html#wp1056041

Matching the Correct Inbound POTS Dial Peer for DID:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00801142f8.shtml#did_cfg

Regards,

- adrián.