02-05-2009 12:36 PM - edited 03-18-2019 10:26 PM
Install of unity connection 2.1 from CD is good until it gets to the end. I get a "security configuration failed" error. The security password is a strong password. The security password is used "to authenticate between clusters", however, I am only using one unit connection server. Any help with this appreciated
Solved! Go to Solution.
02-05-2009 01:26 PM
I would attempt the install again, yes.
02-06-2009 03:09 PM
Awesome! :)
02-05-2009 12:39 PM
This was an old post, wanted to know if anyone had/ having the same issues.
02-05-2009 12:42 PM
This was an old post, wanted to know if anyone had/ having the same issues.
02-05-2009 12:44 PM
Chris,
I saw an issue in the past where the password was "too complex" and a more simple one was re-entered. This ended up resolving the issue. Give that a shot.
Brad
02-05-2009 01:16 PM
Thanks for the fast reply, i tried a couple more simple PW and it's not taking. It runs the Security Configuration and comes back with the same error. I'm not sure if this might be a part of the problem, but when it completed the install and i was getting the error i noticed the DVD ejected itself. should i pop the DVD back in and try again?
02-05-2009 01:26 PM
I would attempt the install again, yes.
02-06-2009 03:07 PM
Brad, i reinstalled and put in a password not to complex and it took.
Mahalo!
02-06-2009 03:09 PM
Awesome! :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide