cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

2538
Views
10
Helpful
6
Replies
Highlighted
Beginner

how to create multiple sip trunks between cucm and cisco unified sip proxy

Dear Expert,

Is there a way to create multiple sip trunks between CUCM and Cisco Unified SIP Proxy (CUSP)? How to achieve it without creating multiple IP interfaces on the CUSP module.

CUCM: 8.5.1.10000-9

CUSP: 8.5.2

Thank you,

.wan

1 ACCEPTED SOLUTION

Accepted Solutions

how to create multiple sip trunks between cucm and cisco unified

Hi

Create multiple SIP Security profiles, with different ports configured - that sets a different source port, so you can then add multiple trunks to CUCM.

That assumes that the far end CUSP can have trunks/peers or whatever set up to use the same IP address with different ports.

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

View solution in original post

6 REPLIES 6
Beginner

how to create multiple sip trunks between cucm and cisco unified

What's the purpose of doing that?

Thanks!

how to create multiple sip trunks between cucm and cisco unified

Hi

Create multiple SIP Security profiles, with different ports configured - that sets a different source port, so you can then add multiple trunks to CUCM.

That assumes that the far end CUSP can have trunks/peers or whatever set up to use the same IP address with different ports.

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

View solution in original post

Beginner

how to create multiple sip trunks between cucm and cisco unified

Hello Aaron,

Thanks for your suggestion.

I'll check it out.

.wan

Beginner

how to create multiple sip trunks between cucm and cisco unified

Hello Michael,

This SIP trunk is part of UCCE solution, which used between CVP, CUSP, and CUCM.

The requirements:

1) To have different codecs for different type of calls, as the phones are at few countries

2) To pass different number of digits from CUSP to CUCM for different call treatments

.wan

Beginner

how to create multiple sip trunks between cucm and cisco unified

In my humble opinion,

1) Different codecs can be controlled by regions.  If you put different phones in different regions in CUCM, you should be able to control the codec negotiation with SIP trunk.

2) This can be done on CUSP (router side) with voice translation rules.

Just my two cents.

Beginner

how to create multiple sip trunks between cucm and cisco unified

Hello Michael, appreciate your suggestions.

1) Yes, we've done this as a temporary solution.

The drawback is phones at the same location, have two different regions, which makes the ext mob feature inflexible

2) I'll check this out.

Many thanks

.wan

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here