After configuring Ethernet port as a unified Uplinks, there is no option shown to set VSAN

[manrsing]

While I was performing the UCS FCoE Uplink Configuration by following " http://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs-manager/116188-configure-fcoe-00.html ".

After configuring Unified Uplink, I am no able to see any field to set VSAN.

Here is the problem screenshot.

[Walter Dey]

Has been discussed recently, see

https://supportforums.cisco.com/discussion/12564991/cisco-ucs-vsan-fur-unifiedfcoe-uplinks

It's since V2.2 !

Walter.