01-20-2011 09:15 AM - edited 03-01-2019 09:48 AM
Is it possible to activate mschap2 on the ucs system?
I only found this:
ucs-A# connect nxosucs-A(nxos)# show aaa authentication login mschapv2MSCHAP V2 is disabled
ucs-A# connect nxos
ucs-A(nxos)# show aaa authentication login mschapv2MSCHAP V2 is disabled
But i can't figure out how to enable it.
01-21-2011 08:35 PM
Martin
What you are looking at is the NXOS plane of FI which is read-only.
When you log into UCS you are authenticated by the methods supported by UCSM and not NXOS.
As NXOS is generic across the Nexus platforms some of the show commands are carried over which don't apply in UCS.
Thanks
--Manish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community