On our 6248UP based UCS systems i have ipv4 multicast snooping set up and that has been working for a long time now.
Now i need to do the same for ipv6 multicast, but i cant find any info about this.
is ipv6 multicast even supported ?
All info is welcome !
I searched through a tech support from a 4.13 LAB domain for 6248, and didn't see any config blocks for that.
The only reference to IPV6 multicast is:
`show cfs status`Distribution : EnabledDistribution over IP : Enabled - mode IPv4IPv4 multicast address : 184.108.40.206IPv6 multicast address : ff15::efff:4653Distribution over Ethernet : Enabled`show cfs internal event-history errors``show cfs internal event-history msgs`Kirk...
Thanks for checking this !
In the UCSmanager UI, under Lan-Policies-Multicast policies there is no mention of ipv6 (i am on 4.21f)
So does this mean that ipv6 MLD is simply not supported ?If i send out ipv6 multicast it is indeed flooded to all hosts in the vlan and that is a showstopper for us
Any idea if this is on the roadmap ? (or where i can find the roadmap ?)
Thanks again !
I haven't found much mention of IPV6 MLD snooping in UCSM context, so I'm guessing it's not on the radar.
I suggest you open a TAC case officially requesting info on the IPV6 MLD snooping, and they can open an enhancement request for the UCSM.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: