cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Field Notice 70545
1158
Views
0
Helpful
2
Replies
RickVestal
Beginner

Cannot clear FSM Faults

I recently added two B200-M2 blades to add to three existing B200-M1 blades. My previous firmware was 1.2.3l and therefore discovery failed on the two M2s. Yesterday we upgraded everything to 1.4.3q, and the M2s discovered properly and everything went fine. Except I cannot clear the two original faults for FSM:Failed even though they went through a full discovery.

Anything I can do? I know that it's just an annoyance but to me it's a huge annoyance. Someone suggested retiring them and moving them elsewhere in the chassis, and creating a new service profile but that would be a last resort. Seems like this should be something easier than that...

1 ACCEPTED SOLUTION

Accepted Solutions
Daniel Laden
Enthusiast

The pictures shows the impacted slots were 1/5 and 1/6.  When the B200M2 were discovered successfully, were they in these slots or others slots.

If there are in different slots, removed one blade from production, decommission the blade, move the bladed to 1/5, discover bladed, discommission blade, repeat in 1/6, move blade back to production location and recommission.

Worst case, you can decommission/recommission the chassis.

HTH,

Dan Laden

View solution in original post

2 REPLIES 2
Daniel Laden
Enthusiast

The pictures shows the impacted slots were 1/5 and 1/6.  When the B200M2 were discovered successfully, were they in these slots or others slots.

If there are in different slots, removed one blade from production, decommission the blade, move the bladed to 1/5, discover bladed, discommission blade, repeat in 1/6, move blade back to production location and recommission.

Worst case, you can decommission/recommission the chassis.

HTH,

Dan Laden

View solution in original post

Decommissioning and recommissioning worked perfect! Thank you very much!

Create
Recognize Your Peers
Content for Community-Ad