Hello ,
i am tryingto download configuration from Cisco FTD with ansible with ftd_file_download module. i am getting following error: ansible.module_utils.connection.ConnectionError: Ansible could not determine the API token path automatically. Ple...
Hello everyone,
i have installed Cisco 9800-CL virtual WLC on vmWare ESXi.
current setup lools like :
WLC has dedicated MGMT interface(GIG1) and trunk port (GIG2).Cisco VPC is configured with ESXi standard switch, with active passive uplink ports....
Hello, can someone tell me the performance of 900 series routers, datasheet tells only encryption performance? i wonder just NAT throughput without any encryption
Hello,i am planing to purchase 9800 virtual wireless controller with 100 x AIR-AP1815I-E-K9. questions are following : 1) can i go with legacy licensing model with AP adder licenses ?2) if there is only AIR-DNA licenses, what will happen if subscript...
i solvedit , inventory file should look like this:
[ftd]myftd ansible_host=<ftd IP>
[ftd:vars]ansible_httpapi_port=443ansible_network_os=ftdansible_user=adminansible_password=temppassansible_httpapi_use_ssl=Trueansible_httpapi_validate_certs=Falsean...
hi @Rich R ,
you are right from hypervisor it is not possible to restrict VLANs on trunk port, unless it is vmware distributed switch. i had standard switch and configured as you described. at this moment everything is ok.
Hello @Rich R ,
we did not have same VLAN on both interfaces, GIG1 had MGMT VLAN and GIG2 all SSID VLANs(exept that MGMT). and this type of config has produced strange traffic loads on bith interfaces.
now it is ok, we just have all nessesary VLANs...
