About JamesLuther

JamesLuther · 08-25-2010

A very quick way to narrow down the problem on the 6500 and 7600 is to use TopN reports. ieType the following to start the TopN reports# collect top 10 counters interface all sort-by utilizationAfter a short time view the reults using# show top coun...

JamesLuther · 05-19-2009

Hi,Does the second switch have a default route pointing towards switch one for the reply packets?Does the first switch have IP routing enabled?Regards

JamesLuther · 05-17-2009

Hi,Have you saved the running config? The bootvar isn't updated until you "copy run start"Regards

JamesLuther · 05-14-2009

Hi,You can check by running show interface. Explanation is underhttp://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080094791.shtmlie in below example (taken from above link) input queue is 75 packets, output queue is WFQ 1...

JamesLuther · 05-08-2009

Hello Nitan,This isn't a problem with your link but rather the way TCP works. Given a particular TCP window size and the latency on the link then there will be a maximum throughput limit. You are finding a difference between the OSes due to the way...

Member Since	‎02-12-2009 04:55 AM
Date Last Visited	‎11-08-2020 07:08 AM
Posts	189
Total Helpful Votes Received	130

User Statistics

User Activity

Re: unicast storm.

Re: Can't access Vlan when connected through another switch

Re: Change the boot var

Re: 3750 buffer value

Re: 180Mbps Limit on 1Gbps NICs