Hi were you able to configure BLF with KEM on 9951, 9971 or 8961 ? From Cisco website: You can program feature key buttons on the Cisco Unified IP Color Key Expansion Module as a directory number, line key, or speed-dial key. The buttons are illuminated, and when configured as a directory number or shared-line keys they allow for easy identification of call state. This capability provides features that are similar to those of typical direct station selection/busy lamp field (DSS/BLF) modules but are not intended to be directly comparable to those of traditional DSS/BLF modules. The Cisco Unified IP Color Key Expansion Module is neither an operator nor an attendant console. Its primary function is to provide the Cisco Unified IP Phone 9971, 9951, and 8961 models with additional keys for features such as speed dial or directory numbers. The illuminated buttons make it easy to determine line status, making the Cisco Unified IP Color Key Expansion Module an ideal call-coverage tool. ... View more

I know it is an old post, but this month I had a similar issue when transmitting FAX over the WAN. Sound was choppy (tones cutting). I just removed "modem passthrough nse codec g711ulaw" and got it working with Cisco fax relay. IOS: 12.4(24)T2. Site 1                                                                               Site 2 FAX---FXS---SCCP---GATEWAY---WAN---GATEWAY---SCCP---FXS---FAX Callmanager is in a different site. Both Gateways have h323 and SCCP configuration. SCCP is only used to register the FXS (fax line) to callmanager. Callmanager config for both gateways: T.38 Fax Relay: Disabled Cisco Fax Relay: enabled Modem Passthrough: enabled Gateway config: voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip fax protocol cisco h323 Regards, Henrique ... View more

I also tried to apply the command "station id-number 41001000" in the voice-port X/X/X:X and it also didn't work. ... View more

Hello Shadi, PBX is connected to the gateway, I don't have access to this equipment. the idea is to change 3251XXXX to 4100XXXX like you said. My custumer states that PBX dial plan cannot be changed. I tried to use Calling Party Transformation and Translation Pattern, but maybe I didn't configure it correctly. I'm not sure if the gateway or CM can perform this digits exchange..Any idea? Thanks, Henrique ... View more

Fixed. I used a different software (freeSSHd). When you get to "Download Directory", just type . Download Directory: . Transfer completed. Using this g.729 that CM converted, it sounds is good. Thank you very much. ... View more

Hi Tommer, thanks for replying. I tried with another g.729 wav file (which was working in a CM) and it worked in IPCCX. Therefore it may be a problem with my converted g729 audio file. Now I want to convert again the raw .wav to g729. I read cisco documents and i can do that by copying the .wav to CM. The problem I'm facing now is to get the g729 file from the CM to my machine. the command is :" file get activelog mohprep/FILENAME.wav" (i'm using CM7). The SFTP server I'm running is Core FTP mini-sftp-server. Everything goes smoothly, but I'm not sure what I should type in "Download Directory:". I keep getting "Invalid download directory specified" error. I'm looking for a solution. thanks! Henrique Ferreira ... View more