Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Hope you can help, I'm trying to find a solution to exclude the following line port from using AAA (ACS TACACS+) authentication on a Terminal Server card on a Cisco 2600 Router. Does anyone know how to do this, or point me in the right direct...
Hi,Can anyone explain this error and what is a stray Segment with the IP ident 46866. I can't seem to find this error on the Cisco web site the only bug appears to be to do with Zone firewalls. I have an 877 Router on a remote site configured with ...
Hi,Does anyone know if there are an issues relate to the Cisco877 router which would cause the IPSEC VPN site to site tunnel to drop and not reconnect, if the router is also configured for Remote access client connection?Just wondered if anyone had t...
Hi All,Hope you can offer some help... I've configured two routers with two NM-CEM-4TE1 cards configured to allow a E1 circuit across an IP network. Setup:2Mbps Tester -------CEM Card ----Router A ----Fa0/0 ------ethernet switch ------Fa0/0---Route...
Hi,You need to use the correct IOS to support the card on the 2811. I've used IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(9)T2, RELEASE SOFTWARE (fc4) the IOS should then allow you to add the card via the card type e1/t1 co...
