Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cisco C240 M6 basically just set up and I am trying to get the CIMC web interface to come up. It is not on the network I am using a small hub and a laptop to connect. If I use a generic 10.10.10.10 255.255.255.0 IP I can bring up the web in...
I am in the middle of setting up a C240 M6 LFF and am trying to setuo CIMC. If I put in a 10.10.10.10, 255.255.255.0 IP scheme I CAN bring up the web interface. If I change the IP to what the network guy gave me I cannot bring up the web interface bu...
Hello,I was handed a Cisco C240 M6 LFF to install ESXi on . The issue is it does not have any hard drives in the front of the unit. There is only a 600GB drive plugged into the rear of the unit similar to this:from what i have found out this drive is...
I am not real knowledgeable of Cisco Servers. I was handed a new server to setup and I am a little confused. It does not have any drives in the front and one 600GB drive plugged into the back. Opening up the server shows that it is a PCIe slot. I hon...
Hi,I was handed a Cisco C240 M6 server to install Ubuntu on. The server is unmanaged and standalone. So I am looking for information on what I need to do to accomplish this. I looked on the Cisco site under this server and "Related Documentation" but...
Still looking to keep this active. I have not revisited this since the developer said they are buying at least one drive for the front. Still I am interested in how I may use the 600GB drive. As far as what the LSI/Avago/RAID BIOS I don't recall see...
Sorry for the late response, sure , here is the SN: WZP26380ZC4. The disk drive is attached to a PCIe card.I believe the server is in UEFI mode. Tried to install ESXi 8.0 and the installer did not find any drives, going to try and use the free versio...
Thanks.No to the first question, do I need that configured?I would assume it is an access port, can get the config I suppose.Are you learning any mac addresses on the upstream switchport? Not sure how to verify that?The background here is the server ...
