Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of 2811 routers that I use in a home lab.
I don't have service contracts on them. Is there any way to upgrade the IOS on them to the latest (15.1.4M12a(MD))?
Both have 15.1.3(T4).
I'm trying to do some configurations around EVN and th...
I have several APs that are being moved to different cities and need to remove them from monitoring in Cisco Prime at their current location and until they are relocated.
I can remove them from the site map, although I'm not sure that would stop aler...
I have several APs that are being moved to different cities and need to remove them from monitoring in Cisco Prime at their current location and until they are relocated.
I can remove them from the site map, although I'm not sure that would stop aler...
I am trying to re-route default route traffic out a different interface than it currently exits.
The problem is that there is an ISP-provided firewall that I have no experience with, and concern that it won't pass traffic that it should or block t...
Hi,
There is a single network statement in BGP (or anywhere) which is the company specific private IP network range. There is a proxy server and proxy scripts involved locally.
I have configuration access to the firewall and that is certainly where f...
Thanks for your reply gpauwen!
The following is the config statements related to this neighbor.
neighbor x.x.x.155 remote-as 10000neighbor x.x.x.155 update-source GigabitEthernet1/1neighbor x.x.x.155 send-communityneighbor x.x.x.155 default-originate...
There is a default VLAN that is configured for every switch. If a port is not tagged with a VLAN ID, it gets sent to the default VLAN. VLAN=subnet (mostly). This tells the switch which other ports may (and may not) receive traffic from this port. The...
