Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are testing Cloud Managed IOS-XE 17.15.4 and upgraded one of the templates and networks to this release. I am seeing hundreds of clients with mac address of 00:00:00:00:00:00 with different public ips and all mapped to interface 1 vlan1. In...
Hello,I am trying to configure backup repository for ISE3.2 in Azure. I can create it but backup would always fail. If I use the same repository for ISE on prem it works just fine. From CLI if i run show repository i get an error message "% Failure...
Hello,We are in the process of migrating from on prem ISE3.0 in to Azure ISE 3.2 with Azure AD. Configuration was migrated manually and now I am in process of testing 802.1x authentication. I know that clients are good, because they are able to use...
Hello,We are running DNAC 2.2.3.4. We purchased couple new Catalyst 9136I-B aps and I am trying to use plug and play to set them up same way I did AP4800 but its failing. Its failing at "Loading Day-0 configuration preview for Devices.." NCOB02082:...
Hello,We are running 6 node ISE 2.7 cluster with 2 Admin nodes and 4 PSN's. I am preparing for 3.0 upgrade and our PSN nodes failed Health check with not enough space. Our PSN nodes were built from 2.4 OVA and at that time disk size requirement wer...
NVM. I do not see those mac address on the stand alone networks. But still showing up on templated networks. looking at the client tracking on the templated networks its setup as MAC Address and stand alone network is configured with Unique client ...
i received an update from Meraki support. Issue was escalated to UI development team.submitted a request to our UI development team asking for assistance resolving this matter. Switch is correctly recognizing the mac addresses, but UI isn't grabbing...
