Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community!I posted about some 2702i in autonomous mode, degrading throughput after some time - see post: Autonomous Mode Failing on Aironet 2702i-z-k9 - Cisco CommunityLast days I got a WLC 2504 and other 2702i access points (in controlled - LWAP...
Hi!I made converted an 2702i from light to autonomous, changing the image to the version: flash:/ap3g2-k9w7-mx.153-3.JC/ap3g2-k9w7-xx.153-3.JCThis image have web interface very unstable (we need to apply many times the configuration to save) and rece...
Hi ! Someone can give me some hints about configuration of this ISR? I have a 1905 working fine in my internet using PPPoE and since this 892 have two WAN interfaces I'm thinking to use it as link fail over, but even in a single link I can't configur...
Hi !I have a 3945 with C3900-UNIVERSALK9-M), Version 15.4(3)M5The router was acquired used and the password recovery was disabled. It's ok for me since I don't want to recover. I just want to blank all the configurations.The problem is that, the rout...
HI Rich! Thanks for your hints.I removed the lower modulations just in case, but for your reference, when the distances from the AP to clients when lowered the throughput was less than 2 meter (same room) The IOS 8.5.182.11 downloaded was not compati...
Hi @Mark Elsen I made the update as you recommended. Used two APs but still the same behaviour. Strange is not? I´m now using an Cambium e410 in the same switch and network without any issue. I want to use the 2702 since have a better performance (wh...
Hi Rasika! I´m making this modification and let´s see. Your recommendation make sense since more encryption loads more the firmware and processor.Just a comment: when the AP degrades the bandwidth, I loose control of the equipment, not responding to ...
Hi Marce! Thanks for your answer but unfortunately I don´t have smartnet contract to download this new image.I will try to get it and keep you posted.Tks,Bernardo
Tks seems it's a new feature. The old 1800/1900 routers don't have it..I have two PPPoE links, I will configure the second interface and will try link failover ;0) as next challenge!Bernardo
