Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So... on reading through several documents and looking at live configurations, it appears as if when you enable vPC Peer-Switch on Nexus switches they will use a virtual Bridge ID for STP calculations.
From what I can see the virtual Bridge ID is alw...
Hi guys,
Something I've been wanting to test for a long time has been Anyconnect on IOS. I've had plenty of joy with Anyconnect on ASAs in the past (configuring/deploying) but for some reason the Anyconnect on IOS is giving me no end of grief. The pr...
A customer is replacing a Cisco 1941 with a Cisco 4331 router. Looked great on paper until I tried to get client VPNs configured. From what I can tell:
PPTP isn't supported (L2TP is but requires a router to act as remote client) Anyconnect isn't supp...
2x Nexus 5548UP + 2x B22HP FEX modules single-homed connected. IOS 5.2(1)N1(6). Seems to be a cosmetic issue and is an annoyance. I'm unsure whether this is normal FEX behaviour or something specific to these B22HP cards (which is basically a FEX fo...
Hi,I was wondering if anyone knew whether or not you can connect an ASR1000 to two separate switches using the same VLAN? If this was an ISR G2 I could have used a BVI interface or installed a switch card and used VLANs. BVI and VLAN doesn't seem to ...
Almost. That bug suggests the issue is fixed by shutting a port. This isn't the case for me. I just get a variation of the log entries that now say "port is admin down" constantly every minute. ON NEXUS 1(Where ports are left "down" in error state) s...
I have the exact same issue and its only for ports connecting to the B22HP FEX. My B22HP cards are single homed to Nexus 5548UPs and I am on 5.2(1)N1(6). The FEX is not changing state at all.Did you source a resolution to this issue? It seems to be c...
I realise this is a very old post however I wanted to post here in case others are still looking for this feature. PBR is now supported in version 6.0(2)N2(1) on Nexus 5k.RELEASE NOTES: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus55...
