About ElshanMammadli5597

ElshanMammadli5597 · 08-08-2025

I want to configure logging on an IOS XR device so that:Syslog server (Graylog) receives all log messagesSplunk server receives only user login and logout messagesI need to configure them separately so that the filters apply only to the Splunk server...

ElshanMammadli5597 · 10-31-2024

We want to pass five vlans in one vlan from customer 1 to customer 2. From A side we must receive VLAN ID 3900 and carry it to B side as vlan 13,14,15,16,17PE Router is on both side NCS540 and IOS version is 7.3.2 . We have tried a lot of l2vpn scena...

ElshanMammadli5597 · 10-29-2024

We have faced load-balance issue on NCS routers. So one of the routers was reloaded and after reload bundle load balance mechanizm runs not correctly. the bundle interface is L2 and there are many subinterfaces.first interface's traffic is 100%, seco...

ElshanMammadli5597 · 09-11-2024

We faced issue related to ISIS. Two N540 connect each other over bundle interface.so we saw that isis is up but ping is unstable. ping's success percent is 30% and appears some logs related to isis bad lsp. we some logs is belowRP/0/RP0/CPU0:Sep 1...

ElshanMammadli5597 · 08-16-2024

We are in trouble with tacacs authentification on Cisco NCS 540.We have configured tacacs and we can login into router but cant do any configuration and also cant do show run.Tacacs is free tacacs server. RP/0/RP0/CPU0:HM(config)#router ospf test% T...

ElshanMammadli5597 · 08-10-2025

This config is like a solution, I tested is and it runlogging 172.22.48.30 vrf mgmt port defaultlogging 172.22.48.30 vrf mgmt discriminatormatch2 SECURITY-SSHD-6

ElshanMammadli5597 · 08-10-2025

This config is like a solution, I tested is and it run logging 172.22.48.30 vrf mgmt port defaultlogging 172.22.48.30 vrf mgmt discriminatormatch2 SECURITY-SSHD-6

ElshanMammadli5597 · 08-08-2025

ElshanMammadli5597 · 08-08-2025

the command "logging discriminator' is not supported on IOS XR . it is supported by IOS XE

ElshanMammadli5597 · 11-03-2024

This configuration doesnt solve our problem. when we write this configuration on both side everthing runs but we recevie vlan 3900 ( all vlans packed in one vlan by customer ) from A and carry it to B side ( which we must depack 3900 to 3707-371...

Member Since	‎03-28-2020 10:57 AM
Date Last Visited	‎12-22-2025 03:47 AM
Posts	44
Total Helpful Votes Received	7

User Statistics

User Activity

IOS XR syslog message filter

MPLS l2vpn multiple vlan to one vlan

NCS 540 bundle load balancing issue

ISIS BAD_PDU_FORMAT

NCS540 tacacs failure

Re: IOS XR syslog message filter

Re: IOS XR syslog message filter

Re: IOS XR syslog message filter

Re: IOS XR syslog message filter

Re: MPLS l2vpn multiple vlan to one vlan