Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, GuysI have ASR903 with single RSP. IOS-XE version is 03.10.00.S.153-3.SWhat procedure I will have to do for upgrade IOS-XE to the newer version. The "Installing and Upgrading Software" guide describes only ISSU procedure (with double RSP configur...
HiIs it possible to do authorization for IOS commands ("conf-t mode") on the TACACS + service without having to keep strings as "privilege configure level 3 interface" in the cisco running config? Authorization for exec mode commands works well but ...
Hi, All1) I need to do http-redirect for IPoE subscribers. Ideally I need to do http-redirect only for some users depending on reply recieved from Radius (accept/reject) or depending on some attribute from Radius. For test I add 15 rule in my control...
First I've done "sh policy-map type pbr interface all". PBR wasn't applied. Then I've removed "deny any any" and [oh, miracle!] IPoE session has established and HTTP-Redirect begun to work correctly. [I do http-redirect by getting VSA with radius ...
Hi AlexanderI need help. A little. Step 1: I have done the both dynamic templates as "type service" as you advise. As before the session is not establish and user host don't get IP-address by dhcp (user get DHCP NAK). ================================...
